| As we all know, diamond (including artificial diamond) saw has already been used extensively in the technology of cutting rock. The saw is made by welting several diamond knife heads on the steel basic body. Diamond knife head consists of diamond and the body holding it. Among the existing technology, diamond knife head's section (vertical section along the moving direction) are mainly rectangle, few arc at the top part. During the cutting course, all rock at the gap of saw should be broken into rock powder by diamond. The diamond has a lot of work to do, so working speed is slow, energy consumption much, production cost high correspondingly. On the occasion cutting thin rock board with large area, the production amount of diamond smashing rock may be one third of rock's total area. Dezeng Knife Head Factory adopts advanced production technology, selects quality material, and provides a new type of diamond knife head. In order to reduce the cutting amount of diamond during the production course of saw, trough is dug on the knife head to form alveolus and groove on the production section, which is good not only for weakening axial violation, increasing pressure of diamond's production section, but also for cooling knife head and discharging rock powder and blocks, increasing production efficiency and life of knife head obviously, reducing cost, therefore creating more benefits for stone material processing enterprises. According to use actually by the masses of customers and on-the-spot test, the new type diamond knife head produced by DeZeng Knife Head Factory can segment more than 200 square meters for 364 board material (stone quality hardness is above 7o), more than 300 square meters for 383 board material (stone quality hardness is 5.5o-6o), more than 2000 square meters for all kinds of marble board material, It has received the unanimous favorable comments from masses of customers at home and abroad. Thank you for your reading, and your visit and orders are welcome! |